.
Liquid Waste Solutions


Trap inspection, what to look for:



The Houston Health department recommends that you inspect your grease trap every time that it is pumped out but they don't tell you what
to look for so here goes:

A. Your trap should be empty, you should be able to see the bottom of the trap.  If their are a few large rocks or concrete chunks  at the
bottom that is not a big issue they could have been left from a sloppy install.  Large objects such as this can not be sucked up through a
vacuum hose on a typical truck. They will have to be removed manually.(we've found tricycles as well!)

B.  Look for any cracks or breaks in the trap itself.  If the cracks or breaks are in the baffles you may have future issues with grease
passing through your trap and into the lines going to the city.  If this happens the line past the trap may back up causing your trap to
explode (over flow) on to the surrounding grass parking lot etc.  At that point the city may get involved issues warnings or fines the
state(TCEQ) may get involved as well. Trust me this is no fun! Then you have the
emergency pump out the emergency plumbing call
and a possible remediation company.
These things are also no fun and can be quit expensive.

C.  Check the walls of your trap especially near the top where the grease collects. Take a close look at  the corners (this is where
contractors cut "corners")there should be no grease caked on to any area of your trap. Your walls should be washed down with a pressure
washer as well.

D. Check the plumbing for breaks cracks etc.  There should be a pipe on the outflow side of the trap that reaches close to the bottom of
the trap which allows clean water to exit the trap grease free and out to the
sample well.

E. Inspectors look at your sample well  and you should too.  This is a window to your grease trap soul!  If you see grease caked to the walls
of yous sample well or you see particulate floating in your waste stream you probably need to pump out more frequently.  Remember, it is
better to figure this out on your own rather than being told by an inspector to do it.  It keeps them happy and that should make your life
easier as well. (no ticket means no ticket, no court ,no fine etc)
who is
john
galt?
grease trap with grease in it!
out flow side of grease trap with missing out flow pipe
What is wrong with this picture?
secondary chamber of grease trap
At first blush this trap has been cleaned well, the walls have
been preasure washed and the cross over pipe is clean. There
are no large rocks at the bottom.

The trap is however missing an out flow pipe that should reach to
the bottom of the grease trap which would prevent grease from
freely exiting the trap to the city. If it had been installed and
knocked off it would reside in the bottom of the grease trap.  In
this case it would appear that it was never installed (probably just
an oversite and the city of Houston  plumbing inspector also
missed it........so much for thoes permit fees (they are suposed to
cover inspections)


Call us for a
trap
inspection!

713-868-1171
pumptruck@gmail.com

Ask for Andy
or Sheryn
Cross over pipe
missing
out
flow
pipe
baffle
For SERVICE or
HELP call
Andy or Sheryn
713-868-1171